Main Article Content
The paper analyses the crack bridging ability of waterproofing coatings used beneath ceramic tiling bonded with adhesives in tests carried out using the test method specified in EN 14891. The study examines 11 products divided into 3 material groups: water dispersions, resin and cement-polymer coatings. The highest resistance in this respect is shown by resin coatings; the least effective are water-dispersion-based coatings. Unfortunately, most tested products do not guarantee waterproofing durability under the climatic conditions of Poland, cracking at elongations of less than 0.75 mm. In addition, it was established that a change in the test speed of the concrete-coating sets from 0.05 mm·min−1 (according to EN 1062-7) to 0.15 mm·min−1 (according to EN 14891) does not significantly affect the elongation at which the first damage occurs, especially at sub-zero temperatures. It is also not possible to draw conclusions about the ability of the coatings to bridge cracks in concrete from the results of mechanical tensile tests performed on thin films, e.g., in accordance with EN ISO 527-1 and EN ISO 527-3.
Article Details
Dimmig-Osburg, A., Pietich, I., & Pakusch, J. (2006). Polymer additives and their influence on the cement microstructure in the early stages of hardening. Zement-Kalk-Gips International, 59, 72–83.
European Committee for Standardization [CEN]. (2000). Products and systems for the protection and repair of concrete structures. Test methods. Reference concretes for testing (EN 1766).
European Committee for Standardization [CEN]. (2004a). Paints and varnishes. Coating materials and coating systems for exterior masonry and concrete. Part 7: Determination of crack bridging properties (EN 1062-7).
European Committee for Standardization [CEN]. (2004b). Products and systems for the protection and repair of concrete structures. Definitions, requirements, quality control and evaluation of conformity. Part 2: Surface protection systems for concrete (EN 1504-2).
European Committee for Standardization [CEN]. (2017). Liquid applied water impermeable products for use beneath ceramic tiling bonded with adhesives. Requirements, test methods, assessment and verification of constancy of performance, classification and marking (EN 14891).
European Committee for Standardization [CEN]. (2018) Plastics. Determination of tensile properties. Part 3: Test conditions for films and sheets (EN ISO 527-3).
European Committee for Standardization [CEN]. (2019). Plastics. Determination of tensile properties. Part 1: General principles (EN ISO 527-1).
Francke, B. (2022). Nowoczesne hydroizolacje budynków. Zeszyt 3. Tarasy i balkony. Wydawnictwo Naukowe PWN.
Francke, B., & Piekarczuk, A. (2020). Experimental investigation of adhesion failure between waterproofing coatings and terrace’s tiles under the usage loads. Building, 10(3), 59. https://doi.org/10.3390/buildings10030059
Fu, W., Wang, L., & Huang, J. Z. (2011) Polymer Cement Waterproof Coating and its Properties (II). Advanced Materials Research, 189–193, 252–255. https://doi.org/10.4028/www.scientific.net/AMR.236-238.2353
Henshell, J. (2016). The Manual of Below-Grade Waterproofing (2nd ed.). CRC Press.
Jiang, Y. J., Li, L., Wang, H S., Wang, R., & Tian, Q. (2015). Influence of Acrylic Emulsion on Polymer-Cement Waterproof Coating. Advanced Materials Research, 1129, 263–269. https://doi.org/10.4028/www.scientific.net/AMR.1129.263
Klem, P. (Ed.). (2026). Budownictwo ogólne. Tom 2. Fizyka budowli. Arkady.
Löfgren, T. (2007). Calculation of crack width and crack spacing. Paper presented at Nordic Mini-seminar: Fibre reinforced concrete, Trondheim.
Oh, K.-h., & Kim, S.-y. (2021). Strain Concentration Ratio Analysis of Different Waterproofing Materials during Concrete Crack Movement. Materials, 14(16), 4429. https://doi.org/10.3390/ma14164429
Papadakis, V. G., Vayenas, C. G., & Fardis, M. N. (1991). Physical and chemical characteristics affecting the durability of concrete. ACI Materials Journal, 88, 186–196.
Tonoli, G. H. D., Santos, S. F., Savastano, H., Delvasto, S., Mejía de Gutiérrez, R., & Lopez de Murphy, M. (2011). Effects of natural weathering on microstructure and mineral composition of cementitious roofing tiles reinforced with fique fibre. Cement and Concrete Composites, 33(2), 225–232. https://doi.org/10.1016/j.cemconcomp.2010.10.013
Wetzel, A., Herwegh, M., Zurbriggen, R., & Winnefeld, F. (2012). Influence of shrinkage and water transport mechanisms on microstructure and crack formation of tile adhesive mortars. Cement and Concrete Research, 42(1), 39–50, https://doi.org/10.1016/j.cemconres.2011.07.007
Wetzel, A., Zurbriggen, R., Herwegh, M., Greminger, A., & Kaufmann, J. (2012). Long-term study on failure mechanisms of exterior applied tilings. Construction and Building Materials, 37, 335–348. https://doi.org/10.1016/j.conbuildmat.2012.07.072
Zhang, J., Liu, C., Sun, M., & Li, Z. (2017). An innovative corrosion evaluation technique for reinforced concrete structures using magnetic sensors. Construction and Building Materials, 135, 68–75. https://doi.org/10.1016/j.conbuildmat.2016.12.157
Zurbriggen, R., & Herwegh, M. (2016). Daily and seasonal thermal stresses in tilings: a field survey combined with numeric modeling. Materials and Structures, 49, 1917–1933. https://doi.org/10.1617/s11527-015-0623-5
Downloads

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.